Dear all I am modeling a steel pipe under cyclic loading. The ultimate strain demand of the pipe ...
- Nader asked 8 months ago
- last active 8 months ago
0 votes
0 answers
1k views
Hi everyone I made a two-dimensional model in Abaqus. I want to define the lateral condition myse...
- yasin asked 11 months ago
- last active 11 months ago
0 votes
0 answers
1k views
Hi everyone. I need to do a 3D voronoi cell in Abaqus, something like this: 3d voronoi abaqus ...
- Daniela Rico asked 1 year ago
- last active 12 months ago
If some nodes of the slave surface are penetrated the master surface in the initial stages and ca...
- Training Group asked 1 year ago
- last active 1 year ago
How can I change the allowed number of severe discontinuity iterations?
- Training Group asked 1 year ago
- last active 1 year ago
I am modelling heat transfer in Abaqus. I have a 2D model exposed to a 50kW/m2 heat flux. I left ...
- Marika du Plessis asked 1 year ago
- last active 1 year ago
Is it possible to observe the forces between contacts or determine the difficulty in establishing...
- Training Group asked 1 year ago
- last active 1 year ago
What is the normal behavior in contact property? What does Hard and Soft contact mean?
- Training Group asked 1 year ago
- last active 1 year ago
What type of step should be used for globally unstable problems such as buckling, collapse, or wh...
- Training Group asked 1 year ago
- last active 1 year ago
In surface-to-surface contacts, which one should be master?
- Training Group asked 1 year ago
- last active 1 year ago
Do we have a provision to modify CLOAD after each iteration by the user in ABAQUS?
- rojinmathews89 asked 1 year ago
- last active 1 year ago
How can we prevent hourglassing from happening?
- Training Group asked 1 year ago
- last active 1 year ago
I am doing a dynamic analysis in Abaqus Standard (Dynamic implicit method), in which, for each in...
- Rojin Mathews asked 1 year ago
- last active 1 year ago
When can we use follower loads, and is there a specific modification to use it?
- Training Group asked 1 year ago
- last active 1 year ago
Which one is the better axial displacement or concentrated force in tensile loading in Abaqus ana...
- Training Group asked 1 year ago
- last active 1 year ago
There is no option for “total force” under the distribution drop down. Why is this?
- Callum Rich asked 1 year ago
- last active 1 year ago
1 vote
0 answers
2k views
Using the damaged plasticity model, I modeled a concrete coupled shear wall in Abaqus, once with ...
- Mehdi asked 2 years ago
Hi, I have a working VUMAT, but I am unable to run a simulation of a composite plate in Abaqus/Ex...
- Raphael Blier asked 2 years ago
- last active 2 years ago
I had a question about the criterion of solid failure? Is it possible to define damage alongside ...
- Aziz Kalantar asked 3 years ago
- last active 2 years ago