1 vote
2k views
Dear all I am modeling a steel pipe under cyclic loading. The ultimate strain demand of the pipe ...
  • Nader asked 2 years ago
  • last active 2 months ago
1 vote
3k views
When can we use follower loads, and is there a specific modification to use it?
0 votes
549 views
What are the Abaqus multiphysics capabilities?
0 votes
2k views
Hope everybody doing well. I have a question on the way to simulate the kinematic hardening for s...
  • Anthos Ioannou asked 3 years ago
  • last active 2 years ago
0 votes
0 answers
2k views
Hi everyone I made a two-dimensional model in Abaqus. I want to define the lateral condition myse...
  • yasin asked 2 years ago
  • last active 2 years ago
0 votes
0 answers
2k views
Hi everyone. I need to do a 3D voronoi cell in Abaqus, something like this: 3d voronoi abaqus ...
  • Daniela Rico asked 2 years ago
  • last active 2 years ago
2 votes
4k views
I want to mesh a pipe elbow contain a single defect in internal wall of extrados by mesh hexa or ...
  • Chaaben asked 4 years ago
  • last active 2 years ago
0 votes
4k views
How can I change the allowed number of severe discontinuity iterations?
0 votes
3k views
What is the normal behavior in contact property? What does Hard and Soft contact mean?
1 vote
2k views
What type of step should be used for globally unstable problems such as buckling, collapse, or wh...
1 vote
3k views
Is it possible to observe the forces between contacts or determine the difficulty in establishing...
0 votes
2k views
I am modelling heat transfer in Abaqus. I have a 2D model exposed to a 50kW/m2 heat flux. I left ...
  • Marika du Plessis asked 2 years ago
  • last active 2 years ago
1 vote
1k views
How can we prevent hourglassing from happening?
1 vote
3k views
Do we have a provision to modify CLOAD after each iteration by the user in ABAQUS?
0 votes
2k views
Which one is the better axial displacement or concentrated force in tensile loading in Abaqus ana...
0 votes
2k views
I am doing a dynamic analysis in Abaqus Standard (Dynamic implicit method), in which, for each in...
  • Rojin Mathews asked 2 years ago
  • last active 2 years ago
1 vote
2k views
There is no option for “total force” under the distribution drop down. Why is this?
  • Callum Rich asked 2 years ago
  • last active 2 years ago
1 vote
0 answers
3k views
Using the damaged plasticity model, I modeled a concrete coupled shear wall in Abaqus, once with ...
1 vote
3k views
Hi, I have a working VUMAT, but I am unable to run a simulation of a composite plate in Abaqus/Ex...
  • Raphael Blier asked 3 years ago
  • last active 3 years ago
1 vote
2k views
I had a question about the criterion of solid failure? Is it possible to define damage alongside ...
  • Aziz Kalantar asked 4 years ago
  • last active 3 years ago
Showing 20 results