Hello, I am a new user of Abaqus and its libaray UMAT. Since I need to perform some CPFEM simula...
- Training Expert asked 8 months ago
- last active 8 months ago
Salutations to all. I’m new to UMAT in Abaqus and would like to construct UMAT for “s...
- Training Expert asked 9 months ago
- last active 9 months ago
Hi All, I am simulating the development of oxide layers on metal and I have referred to the follo...
- Training Expert asked 9 months ago
- last active 9 months ago
I’m going to use XFEM crack to run a crystal plasticity model. USER MATERIAL describes the ...
- Training Expert asked 10 months ago
- last active 10 months ago
Hello everybody Hope you’re doing great Assume I have two material properties MATERIAL1 and MATE...
- Training Expert asked 10 months ago
- last active 10 months ago
Hello. I’m about to start a research project on fault rupture in soil, and I found that the...
- Training Expert asked 10 months ago
- last active 10 months ago
Hello Abaqus users, I’m writing UMAT for fatigue analysis. I use direct cyclic step for ca...
- Training Expert asked 11 months ago
- last active 11 months ago
Hello I try to write a UMAT subroutine for shape memory alloy material. Does anyone have a UMAT s...
- vlasis.d asked 3 years ago
- last active 6 months ago
