I am modelling heat transfer in Abaqus. I have a 2D model exposed to a 50kW/m2 heat flux. I left ...
- Marika du Plessis asked 2 years ago
- last active 2 years ago
Dear all, Regarding the similarity of the 2D and 3D cohesive zone models, I have a tiny question....
- Training Expert asked 2 years ago
- last active 3 months ago
I’m using ABAQUS to create a 3D End Notched Flexure test. Two beams with a cohesive element...
- Training Expert asked 2 years ago
- last active 3 months ago
How to a 3D printing simulation in Abaqus?
- Training Expert asked 10 months ago
- last active 3 months ago
What is 3D printing? What are the 3D printing types?
- Training Expert asked 10 months ago
- last active 3 months ago
Hi, I have a working VUMAT, but I am unable to run a simulation of a composite plate in Abaqus/Ex...
- Raphael Blier asked 3 years ago
- last active 3 years ago
0 votes
0 answers
2k views
Hi everyone. I need to do a 3D voronoi cell in Abaqus, something like this: 3d voronoi abaqus ...
- Daniela Rico asked 2 years ago
- last active 2 years ago
0 votes
0 answers
2k views
Hi everyone I made a two-dimensional model in Abaqus. I want to define the lateral condition myse...
- yasin asked 2 years ago
- last active 2 years ago
Hello DAMASK and ABAQUS users, I want to run dislocation density based crystal plasticity finite ...
- Training Expert asked 2 years ago
- last active 3 months ago
I’m using Abaqus to simulate a pillar with brittle material subjected to nanoindentation, w...
- Training Expert asked 2 years ago
- last active 2 years ago
0 votes
0 answers
2k views
I try to make a rock blast in abaqus. TNT(eulerian element) defination I used is JWL equation ,an...
- stanandjackson asked 2 years ago
0 votes
0 answers
485 views
Currently, I am building a vehicle with a single degree of freedom running on a bridge. I previou...
- n311612011.en11 asked 7 months ago
0 votes
0 answers
1k views
How can you encrypt a .inp file? The documentation of Abaqus seems clear but when I put the comma...
- Jesus asked 2 years ago
What are the Abaqus multiphysics capabilities?
- Training Expert asked 11 months ago
- last active 11 months ago
0 votes
0 answers
2k views
Hello team. I am looking for a UEL file for a simple elastic 2D and/or 3D higher-order element (q...
- vlasis.d asked 2 years ago
0 votes
0 answers
724 views
I applied 1000 N force and 900 hz frequency using the Steady State Dynamic Direct method but afte...
- Arfin Shahadat asked 12 months ago
If some nodes of the slave surface are penetrated the master surface in the initial stages and ca...
- Training Group asked 2 years ago
- last active 7 months ago
0 votes
0 answers
679 views
Hello, CAE Assistant. Nice to meet you here! Briefly, I would like to show you my problem below. ...
- sothunchhaer6 asked 1 year ago